Memory Card Explorer for RICOH

Version 1.00 to 1.10 Patch Program

Important Notice to MCERICOH Version 1.00 Users

Thank you for purchasing MCERICOH Version 1.00.
Due to the problems with the software development kit, your MCERICOH Version 1.00 has some major problems causing your computer to have a system crash. So, you must install the Version 1.00 to 1.10 patch program before you use the MCERICOH software. We are very sorry for the inconvenience.

Please download the patch program from the following link and follow the installation instructions below.

Download the V1.00 to 1.10 Patch Program
(110update.exe, 1,146,880 bytes)

[Known Problems with MCERICOH Version 1.00]

If you have not tested the MCERICOH software using the demo version, we strongly recommend that you download the demo version first for 30-day trial use.

MCERICOH V1.10 Demo Version
(110demo.exe, 3,145,728 bytes)

Installation

The MCERICOH Version 1.00 to 1.10 Patch installation takes 3 steps.

Preparation
MCERICOH V1.00 Installation
MCERICOH V1.00 to V1.10 Patch Program Installation

1. Preparation

Before you start the MCERICOH installation, you must prepare the following.

A computer with PC card slots

Remove all PC cards before you start installation.

Ensure that no 3rd party PC card management software is installed.

Windows 95/98/Me: Ensure that the PC card service has correctly been configured.

MCERICOH version 1.00 installation disks with a valid software license

Ensure you have three installation disks purchased from a local Ricoh subsidiary or from an OEM partner.

You can find the software license label on the disk 1.

If you do not find the license label, your installation disks are illegal copies. Installation using illegally copied disks is prohibited.

MCERICOH version 1.00 to 1.10 patch program

Download this patch from the above link to your computer's local hard disk.

A flash memory card for product firmware upgrade

The blue 4MB flash memory card(Ricoh part number A2309350).

A binary file

Any product firmware file is OK.

2. MCERICOH V1.00 Installation

First, install MCERICOH version 1.00 on your computer using the installation disks.
Refer to the User Guide for step by step installation instructions.
MCERICOH User Guide (PDF format)

After you finish installation, proceed to the patch program installation immediately.

3. MCERICOH V1.00 to V1.10 Patch Program Installation

Execute 110update.exe from your computer's local hard disk.
When you are requested to fill in registration information, you may need to input them again.
After the patch program installation has finished, restart the computer.

4. Getting Started

The first time you start MCERICOH V1.10, you may need to configure the operating system and the MCERICOH settings.
The configuration procedure differs depending on the operating system you are using. Refer to one of the following links.
Windows 95, 98, and 98 Second Edition
Windows Millennium Edition
Windows NT4.0 Workstation
Windows 2000 Professional

[Back to MCERICOH Home]