Fax Number Input Mode
Fax number input mode becomes active when entering fax numbers. In this mode, use the keys as follows:
To enter a number
Press a number key.
To enter characters other than digits
“*”: Press the [
] key.“#”: Press the [
] key.“+”: Press [0] twice.
Pause: Press the [Pause/Redial] key. A pause is indicated on the screen as a “P”.
Space: Place the cursor on the right-most character, and then press the [
] key. To move the cursor left or right
Press the [
] key to move the cursor left, and the [] key to move the cursor right.If you enter a character when there is a character at the cursor position, the current character shifts to the right.
To delete a character
Place the cursor on the character you want to delete, and then press and hold the [
] key until the character is deleted.To delete all characters
Press the [Clear/Stop] key.
Some characters other than digits cannot be used, depending on the setting you are configuring.
When the maximum number of characters has already been entered, characters entered subsequently are ignored.
