Previous
The printer's Ethernet port is not available when the Gigabit Ethernet board is attached to the printer. Use the Ethernet port on the Gigabit Ethernet board.
Check the contents of the package.
Gigabit Ethernet board
Protective caps (2)
Ferrite core
(mainly North America)This item is not included with the Gigabit Ethernet board.
Turn the printer off and unplug the power cord.
Unplug the cable from the Ethernet port, and then cover it with the protective caps.
Loosen the two screws and remove the slot cover.
The removed cover will not be reused.
Fully insert the interface board.
Confirm that the interface board is firmly connected to the controller board.
Tighten the two screws to secure the interface board.
Confirm that the board was correctly installed by printing the configuration page. If it is correctly installed, "Gigabit Ethernet Board" will appear for "Device Connection" on the configuration page. For information about printing the configuration page, see Test Printing
.If the board was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.
Before using the board, you must configure settings from the control panel. For details, see Ethernet Configuration
.
