Skip header
 

Combined Copying

This section describes how to make combined copies.

Note

  • The ADF is required to scan 2-sided originals.

  • When placing originals on the exposure glass, start with the first page to be copied. When placing originals in the ADF, set the first page on top.

  • When placing originals on the exposure glass, press the [Sharp] key after all the originals have been scanned.

  • In this mode, the machine selects the reproduction ratio automatically. This reproduction ratio depends on copy paper sizes and the number of originals.

  • The reproduction ratios selectable by the machine are 50-200%.

  • If the calculated ratio is under the minimum ratio, it is automatically adjusted to within available range. However, with some ratios, parts of the image might not be copied.

  • You cannot use custom size paper.

  • If the orientation of originals is different from that of the copy paper, the machine will automatically rotate the image by 90° to make copies properly.

  • If the number of originals placed is less than the number specified for combining, the last page segment is left blank as shown.

    Illustration of Combined Copying