Skip header
 

Custom sizes

When placing a custom size original on the exposure glass or in the ADF, specify the size of the original using the number keys.

Important

  • Original sizes that can be set with this function are:

    • ADF: vertical 139-216 mm (5.5-8.5 inches), horizontal for 1-sided originals 139-1260 mm (5.5-49.6 inches), horizontal for 2-sided originals 160-356 mm (6.3-14 inches)

    • Exposure glass: vertical 139-216 mm (5.5-8.5 inches), horizontal 160-356 mm (6.3-14 inches)

1Select the bypass tray Operation panel screen illustration using [Up arrow key] or [Down arrow key].

Operation panel screen illustration

2Press the [Sharp] key.

3Select [Original Size] using [Up arrow key] or [Down arrow key], and then press the [OK] key.

Operation panel screen illustration

4Select [Custom Size] using [Up arrow key] or [Down arrow key], and then press the [OK] key.

Operation panel screen illustration

5Enter the horizontal size of the original (Horiz.) with the number keys, and then press the [OK] key.

Operation panel screen illustration

6Enter the vertical size of the original (Vert.) with the number keys, and then press the [OK] key.

Operation panel screen illustration

The “Programmed” message appears.

When the custom size originals settings are registered, Operation panel screen illustration appears on the top of the copy display.

Operation panel screen illustration

Note

  • To change the value you entered, press the [Clear/Stop] key, and then enter a new value.

  • To cancel the size you have set, press the [Clear Modes] key.