Making Network Settings for Using Netware

If you use NetWare, select the frame type for NetWare.

Select one of the items below if necessary.

Usually, use the default setting ([Auto Select]). When you first select [Auto Select], the frame type detected by the printer is adopted. If your network can use more than two frame types, the printer may fail to select the correct frame type if [Auto Select] is selected. In this case, select the appropriate frame type.

Press the [Menu] key.
Press the [] or [] key to display [Host Interface], and then press the [#Enter] key.

Menu: Host Interface
Press the [] or [] key to display [Network Setup], and then press the [#Enter] key.

Host Interface: Network Setup
Press the [] or [] key to display [Frame Type (NW)], and then press the [#Enter] key.

Network Setup: Frame Type (NW)
Press the [] or [] key to select the frame type, and then press the [#Enter] key.
Press the [Menu] key.
The initial screen appears.
Print a configuration page to confirm the settings made.
- For details about printing the configuration page using control panel, see Test Printing.