Forwarding
This section describes how to specify Forwarding.
Specify when programming a Special Sender.
One forward destination can be registered for each Special Sender. To register two or more forward destinations, use group destinations. Up to 100 destinations can be specified in a group. However, when adding a group to another group, a maximum of 150 destinations can be specified in a group.
Select [Forwarding] using [
] or [
], and then press the [OK] key.
Select [On] or [Off] using [] or [], and then press the [OK] key.
Selecting [Same as Basic Settings] will result in the same setting made for [Forwarding] under [Administrator Tools].
If you select [Off] or [Same as Basic Settings], the display returns to that of step 1.
Specify an End Receiver using the Quick Dial keys, and then press the [OK] key.
Press the [OK] key.
In Step 3, you can search for and specify the forwarding destination by pressing the [Search Destination] key or a User Function key. To specify a forwarding destination by pressing a User Function key, you must first register the [Specify Dest. Reg. No.] function as a User Function key. For details about User Function key, see “General Settings/Adjust”.
