Basic Procedures for Sending a Fax

Press the [Fax] key, and make sure the [Memory Trans.] indicator lights.

If it is lit, memory transmission mode is selected.

Normally memory transmission mode is selected.

To fax in immediate transmission mode, press the [Memory Trans.] key. The indicator will now be unlit.

Place the original.

To change the scan settings, press the [Resolution] key, and then specify the settings.

Specify the destination.

SUB=            [1]

If you press a Quick Dial key, the destination assigned to it appears on the display and transmission begins automatically. You do not have to press the [B&W Start] key as in step . (below).

If you make a mistake, press the [Clear/Stop] key, and then enter the correct number.

Press the [B&W Start] key.

If you have placed the original on the exposure glass, proceed to step .

The transmission starts.

After transmission, the initial screen appears.

To cancel a fax during sending, press the [Clear/Stop] key, and then remove the original.

Press [Yes] key.

Scan Ex. Glass(A4)  Scan=Yes (Size=)

Press the [B&W Start] key.

Next Page? (A4) 1  Scan=Yes (TX=Start)

The transmission starts.

After transmission, the initial screen appears.

To cancel a fax during sending, press the [Clear/Stop] key, and then remove the original.